ar6850b0100a

Remove/install roller sun blind on tilting roof

Type ar · topic 68.50 · version 0100 · 2016-02-12

Applies to: Body 693.8 with Vehicle 693

Where it sits

Function group 3 Body › 68 Interior equipment › 68.50 Curtains, roller blinds, luggage nets, cargo retainers — Series 693

EinPAS 38 Roof system › 38.30 Roof hatch/emergency exit/roof vent flap › 38.30.40 Roller blind/cassette/trim — Series 693

AR68.50-B-0100A

Remove/install roller sun blind on tilting roof

12.02.16

Body 693.8 with Vehicle 693

Remove/install roller sun blind on tilting roof

W68.50-0007-03

1 Glass hatch frame

2 Plastic rail

3 Support of the retractable roller blind

4 Bearing support of the retractable roller blind

5 Bearing support of the retractable roller blind

6 Retractable roller blind

7 Shaft of the retractable roller blind

Remove

1

Remove the curtain rail

AR68.50-B-5610A

2

Remove the glass hatch frame (1) and place it on safe place

AR77.55-B-6150B

3

Remove the plastic rails (2)

Careful in order not to damage the plastic rails.

4

Rotate the glass hatch frame (1) and loosen the screws from the support (3) of the retractable roller blind

5

Remove the screws of the support (4) and (5) of the retractable roller blind bearing

The retractable roller blind is under spring tension, for this reason, loosen the blind carefully.

6

Remove the retractable roller blind from the glass hatch frame (1), removing it in the direction indicated by the arrow

Installing

7

Install the retractable roller blind (6) in the guide and in the glass hatch frame (1) and position the support (4) of the blind bearing with the respective screw

In the case of the version with double retractable roller blind, install first the insect protection curtain.

Position the screw in support of the retractable roller blind, however, without tightening it

8

Keep the shaft of the retractable roller blind (7) pressed and position the support (5) of the blind bearing with the respective screw

Maintain the retracted blind pressed on the shaft. Position the screw on the support of the blind bearing, without tightening it.

9

Position the support (3) of the retractable roller blind (3) with the respective screws

Control the initial tension of the blind after installed. If necessary increase the tension.

10

Tighten the screws of the supports (3) from the retractable roller blind and, next, tighten the screws of the bearing supports (4) and (5)

Careful to avoid thread damage.

11

Fasten the plastic rail (2) on the glass hatch frame (1)

Careful in order not to damage the plastic rails.

12

Install the glass hatch frame (1)

AR77.55-B-6150B

13

Install the curtain rail

AR68.50-B-5610A

Check

14

Check the operation of the retractable roller blind

Referenced documents