ar6830p4786s

Remove/install rear center section cover

Type ar · topic 68.30 · version 0100 · 2020-08-17

Applies to: Model 223

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 223

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.34 Trunk lining — Series 223

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.35 Load compartment trim — Series 223

AR68.30-P-4786S

Remove/install rear center section cover

22.07.2020

Model

223

Remove/install rear center section cover

	P68.30-A074-76
1	Rear center section paneling
2	Expansion rivet
3	Bracket
4	Trunk floor

P00.00-4149-06

 Warning	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
 	Remove/install
1	Open trunk lid.
2	Lift trunk floor (4).
3	Remove expansion rivets (2).	 Dismantling tool	*000589956300
4	Release holders (3) with a suitable tool and unclip with the special tool.	 Dismantling tool	*000589956300
5	Unclip rear-end center section cover (1) and remove upward.	 Long wedge	*115589035900
6	Install in the reverse order.

Remove/install rear center section cover

Remove/install rear center section cover

000 589 95 63 00

Dismantling tool

115 589 03 59 00

Long wedge

Referenced documents

ah8061p000101a Notes on HANDS-FREE ACCESS
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.