ar6830p4786lwt

Remove/install rear center section cover

Type ar · topic 68.30 · version 0100 · 2016-07-16

Applies to: Model 213.2

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 213 (models 2**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.34 Trunk lining — Series 213 (models 2**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.35 Load compartment trim — Series 213 (models 2**)

AR68.30-P-4786LWT

Remove/install rear center section cover

06.07.2016

Model

213.2

Remove/install rear center section cover

P68.30-3927-09

1	Rear center section paneling		4	Retaining clips
2	Load compartment floor rear section		5	Frame seal
3	Screw

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on sensor system for trunk lid opening/closing	Model 213.2 with code P17 (KEYLESS-GO package)	AH80.61-P-0001-01A
 	Remove/install
1	Fold over load compartment floor rear section (2)
2	Remove bolts (3)
3	Remove retaining clips (4)
4	Unclip rear center section paneling (1) and remove	 Installation: Ensure that sealing frame (5) is seated correctly.
		 Mounting wedge	*110589035900
5	Install in the reverse order

Remove/install rear center section cover

110 589 03 59 00

Mounting wedge

Referenced documents

ah8061p000101a Notes on HANDS-FREE ACCESS
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.