ar6830p4700gh

Remove/install paneling on B-pillar

Type ar · topic 68.30 · version 0106 · 2003-03-18

Applies to: MODEL 163.113 /128 /136 /154 /157 /172 /174 /175

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 163 (models 113, 128, 136, 154, 157, 172, 174, 175)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.30 Vehicle interior/passenger compartment trim — Series 163 (models 113, 128, 136, 154, 157, 172, 174, 175)

AR68.30-P-4700GH

Remove/install paneling on B-pillar

6.3.97

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175

Remove/install paneling on B-pillar

P68.30-0535-09

1 Belt end fitting bolt

2 Sheet metal screw

5 Top trim panel

6 Seat belt height adjuster

3 Bottom paneling

4 Sheet metal screw

Remove/install

Removal

Risk of fracture and crackingof plastic paneling parts and the associated clip retainers

1

Remove door sill molding

AR68.30-P-4100GH

2

Pull off front and rear rubber door seal in the area of the B-pillar

3

Unscrew screw for belt end fitting (1) from seat

*BA91.40-P-1001-01D

4

Remove bottom paneling (3)

5.1

Remove SRS label and unscrew screw behind

As of 1.9.01.

6

Unscrew sheet metal screws (4) from upper paneling

7.1

Unclip top panel (5)

As of 1.9.01: clips are no longer present.

Installation: The lug of the seat belt adjusting device (6) must align with the recess of the paneling. Check mounting clips and replace if damaged.

8

Install in the reverse order

Safety belts/emergency tensioning retractors

Number

Designation

Model 163 up to 08/99

Model 163 as of 09/99

BA91.40-P-1001-01D

Belt end fitting screw

Nm

35

35

Referenced documents