P68.30-3508-09
Shown on right side of vehicle |
1 | Upper C-pillar paneling | 6 | Upper side load compartment paneling | 11 | Bolts | ||
2 | Guide rail | 7 | Cutout | 12 | Fixtures | ||
3 | Lower D-pillar paneling | 8 | Guide tube | 13 | Clips | ||
4 | Cover frame | 9 | Rear backrest release handle | 14 | Cover frame (with code (844) Folding bench seat in cargo area, opposite direction of travel) | ||
5 | Rear center section paneling | 10 | Electrical connector |
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Notes on sensor system for trunk lid opening/closing | ||
| Remove/install | ||
1 | Remove upper side load compartment paneling (6) | ||
2 | Remove rear center section paneling (5) | ||
3 | Unclip cover frame (4) from rear (arrow) toward center of vehicle | Clip remover | |
4 | Lift lower C-pillar paneling (3) from bottom and unclip toward center of vehicle | Clip remover | |
5 | Loosen guide tube (8) on rear backrest release handle (9) | Installation: Insert guide tube (8) into omega clips. | |
6 | Unscrew nut on rear backrest release handle (9) and remove rear backrest release handle (9) | Do not remove Bowden cable from rear backrest release handle (9). | |
7 | Disconnect electrical connector (10) and remove from bracket | Only for removing guide rail (2). | |
8 | Remove bolts (11) | ||
9 | Remove guide rail (2) downward from upper D-pillar paneling (1) | For removing upper D-pillar paneling (1) allow guide rail (2) to hang down on electrical wiring harness. | |
10 | Loosen upper D-pillar paneling (1) from clips (13) | ||
11 | Disconnect electrical connector from cargo area lamp | ||
12 | Disconnect electrical connector from speaker | MODEL 212.2 | |
13 | Unclip cover frame (14) from upper D-pillar paneling (1) to center of vehicle | MODEL 212.2 | |
Do not remove cover frame (14) from seat belt. | |||
Clip remover | |||
14 | Pull upper D-pillar paneling (1) toward rear out of cutouts (7) and remove | Installation: Ensure that fasteners (12) are seated correctly in recesses (7) and in relation to headliner. | |
15 | Install in the reverse order |
452 589 01 63 00
Clip remover
Referenced documents
- ah8061p000101a Notes on HANDS-FREE ACCESS
- ar6830p1180es Remove/install load compartment inner side paneling
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.