ar6830p4490me

Remove/install trim at C-pillar

Type ar · topic 68.30 · version 0101 · 2019-05-31

Applies to: Model 167.1

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 167 (models 1**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.30 Vehicle interior/passenger compartment trim — Series 167 (models 1**)

AR68.30-P-4490ME

Remove/install trim at C-pillar

04.04.2019

Model

167.1

Remove/install trim at C-pillar

P68.30-4108-09

1

C-pillar paneling

5

SRS cover

2

Seat belt

6

Guide

3

Edge guard

7

D-pillar paneling

4

Belt end fitting

8

Cover

Notes on safety-relevant components

AH00.00-Z-0019-01A

Remove/install

1

Remove corresponding side trim in trunk.

AR68.30-P-4800ME

2

Remove seat belt end fitting (4).

Bolt, rear belt end fitting

*BA91.40-P-1005-01U

3

Remove edge guard (3) in area of C-pillar trim (1).

Installation: Ensure that edge guard (3) is seated correctly.

4

Remove SRS cover (5).

5

Detach C-pillar trim (1) from C-pillar and D-pillar trim (7), slightly tilt toward vehicle center, and move out toward front.


Carefully remove C-pillar trim (1).
Otherwise roof paneling can be damaged.

Installation: The guide (6) of the C-pillar trim (1) must retract into the D-pillar trim (7) correctly.

6

Remove cover (8) from C-pillar trim (1).

7

Guide seat belt (2) out through opening and remove C-pillar trim (1).

Check

8

Check expansion rivets of C-pillar trim (1) for damage.

If expansion rivets of C-pillar trim (1) are damaged:

Replace expansion rivets of C-pillar trim (1).

9

Install in the reverse order.

Seat belts/emergency tensioning retractors

Number

Designation

Model 167

BA91.40-P-1005-01U

Bolt, rear belt end fitting

Nm

35

Referenced documents