ar6830p4320qa

Removing and installing soft top paneling

Type ar · topic 68.30 · version 0102 · 2017-10-07

Applies to: Model 207.4, 209.4

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 207 (models 4**) · Series 209 (models 4**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.32 Roof lining — Series 207 (models 4**) · Series 209 (models 4**)

AR68.30-P-4320QA

Removing and installing soft top paneling

21.09.2017

Model

207.4, 209.4

Removing and installing soft top paneling

Shown on model 209.4

1

Front paneling on soft top

2

Bolts

3

Mounting clips

P68.30-2682-06

Warning

Risk of injury when performing check and repair work in area of roll bar

Before working in the area of roll bar, completely extend rear head restraints.
Keep body parts out of the area where the roll bar extends.Model 207.4

AS91.00-Z-0003-01A

Warning

Risk of injury when performing check and repair work in area of roll bar

Before working in the area of the roll bar, pull out rear head restraints by hand.
Keep body parts out of area where roll bar extends.Model 209.4

AS91.00-Z-0003-01QA

Remove/install

1

Open soft top

Lay soft top into soft top compartment, do not close soft top compartment.

2

Cover vehicle in rear area


Cover vehicle.
Paintwork damage will otherwise occur.

3

Remove screw/bolts (2)

4

Unclip trim on front soft top (1) in upward direction

Installation: Check mounting clips (3), replace if necessary.

5

Install in the reverse order

Referenced documents