ar6830p430010q

Prepare headliner for installing telephone wiring harness

Type ar · topic 68.30 · version 0101 · 2010-03-29

Applies to: MODEL 209.3 with CODE (273) Provision for D-network handy telephone MODEL 209.3 with CODE (329) Preinstallation for AMPS telephone system MODEL 209.3 with CODE (386) Preinstallation for "portable CTEL" UPCI telephone system MODEL 209.3 with CODE (388) "Portable CTEL" UPCI telephone system MODEL 209.3 with CODE (498) Japanese version MODEL 209.3 with CODE (852) CTEL preinstallation assembly at dome MODEL 209.3 with CODE (853) MB standard cellular telephone MODEL 209.3 with CODE (854) MB portable

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 209 (models 3**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.32 Roof lining — Series 209 (models 3**)

AR68.30-P-4300-10Q

Prepare headliner for installing telephone wiring harness

Repair materials

Number

Designation

Order number

BR00.45-Z-1071-02A

Adhesive tape roll, gray Tesa tape, 50 meters 0.3X50, 236 mm

A 001 989 17 85

Prepare headliner for installing telephone wiring harness

P68.30-2814-06

Shown on model 209.3 with code (414a) Electric glass tilting/sliding roof and code (220a) Parktronic system (PTS) and code (882b) Interior monitoring (only with ATA)

1 Headliner

2 Sound system wiring harness (with code (810) Sound system)

3 Cable harness, telephone

1 Lay new headliner (1) down on suitable subsurface.

2 Place suitable clean spacers, e.g. foamed material or styrofoam pads below new headliner.

Do not use any hard or sharp-edged objects, otherwise covering of new headliner (1) will be damaged.

The foamed material or styrofoam pads prevent the new headliner (1) from sagging when performing the following steps.

3 Route new telephone wiring harness (3) on new headliner (1) starting at overhead control panel control module opening.

The old headliner (1) serves as template for routing the wiring harness.

4 Glue new telephone system wiring harness (3) onto new headliner with an approx. 10 cm long strip of adhesive tape at a distance of approx. 10 cm.

Do not overcross new telephone wiring harness (3) and sound system wiring harness (2) (with code (810) Sound system) and sufficiently press on strips of adhesive tape, otherwise a short circuit on the headliner can result from chafing.