P68.30-4036-09
Shown on model 177.0 with code 810 (Sound system) |
1 | A-pillar paneling | 5 | Guides | |
2 | Cover | 6 | Clip | |
4 | Clip |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Notes on safety-relevant components | |||
| Remove/install | ||
1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
2 | Unclip cover (2). | Installation: Ensure that clip (4) is seated correctly. | |
Dismantling tool | |||
3 | Unclip trim from the A-pillar (1) in the top area and pivot slightly at the top toward the inside. | Installation: Ensure that edge guard is seated correctly. | |
Long wedge | |||
4 | Guide trim on the A-pillar (1) toward the top out of the instrument panel until the electrical connectors are accessible. | The number of electrical connectors varies according to vehicle equipment. | |
5 | Release and disconnect electrical connector. | Model 118, 177, 247 | |
6 | Remove trim from the A-pillar (1). | Installation: Ensure that the A-pillar trim (1) can be inserted correctly into the guides (5). | |
Installation: Ensure that the clip (6) engages properly. | |||
7 | Remove left A-pillar tweeter (H20/1) and right A-pillar tweeter (H20/2). | Model 118, 177, 247 | |
8 | Install in the reverse order. |
000 589 95 63 00
Dismantling tool
115 589 03 59 00
Long wedge
Referenced documents
- ah0000z001901a Notes on safety-relevant components
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.