ar6830l4050va

Removing and installing paneling on A-pillar

Type ar · topic 68.30 · version 0100 · 2003-03-13

Applies to: MODEL 414.700

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 414 (models 700)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.30 Vehicle interior/passenger compartment trim — Series 414 (models 700)

AR68.30-L-4050VA

Removing and installing paneling on A-pillar

11.7.01

MODEL 414.700

Removing and installing paneling on A-pillar

L68.30-0008-09

1 A-pillar paneling

2 Edge guard

3 Instrument panel

7 Clip

8 B-pillar paneling

9 Retaining clip

4 Bolt cover

5 Bolt

6 Grab handle

Removing, installing

1

Pull off edge guard (2) on A-pillar in area of A-pillar paneling (1)

2.1

Open bolt covers (4), unscrew bolts (5) and remove grab handle (6)

When removing the right A-pillar paneling

2.2

Unclip clips (7) using assembly wedge

When removing the left A-pillar paneling

Installation: Check condition of clips (7) and replace if necessary.

*110589035900

3

Unclip B-pillar paneling (8) at the top (arrow)

4

Carefully unclip A-pillar paneling (1) using assembly wedge, pull out of instrument panel (3) at the bottom and remove

Pass the assembly wedge close up to each of the retaining clips (9). Check condition of retaining clips (9) and replace if necessary.
Installation: Ensure that tabs (arrows) are properly seated in the instrument panel (3).

*110589035900

5

Install in the reverse order

Removing and installing paneling on A-pillar

Assembly wedge

110 589 03 59 00