1 | Seal |
2 | Rear-wall window |
3 | Screwdriver |
4 | Cup suction tool |
W67.20-0001-06
W67.20-0002-09
1 | Seal | 6 | Imprint | A | Overlap area of pulling cord | ||
2 | Rear-wall window | 7 | Rear panel | ||||
5 | Pulling cord | 8 | Cover |
| Remove | ||
1 | Remove upper bunk | Only on vehicles with code D3A (Deluxe bed, top, wide, adjustable). | |
Vehicles with code F4I (Cab rear panel, with window) | |||
2 | Install cup suction tool (4) on inside of rear-wall window (2) | ||
3 | Pry rubber lip on seal (1) from vehicle interior over edge of rear wall (7) toward outside with screwdriver (3) | Hold rear-wall window (2) with cup suction tool (4). | |
4 | Remove rear-wall window (2) with cup suction tool (4) | ||
5 | Remove seal (1) from rear-wall window (2) | Check seal (1) and rear-wall window (2) for reusability. | |
| Install | ||
6 | Pull seal (1) over edge of rear-wall window (2) | Install with angled long sealing lip (1) pointing toward vehicle interior. The imprint (6) on the rear-wall window (2) should be easily legible. | |
7 | Insert pull-in cord (5) all the way around rear-wall window (2) below the long rubber lip of seal (1) | The overlap area of the pull-in cord (A) should be approx. 10 cm long. | |
8 | Coat angled side of seal (1) with lubricant | Lubricant | |
9 | Press rear-wall window (2) uniformly against window frame from outside with installed seal (1) | Allow free ends of pull-in cord (5) to hang down in vehicle interior. | |
10 | Uniformly pull free ends of pull-n cord (5) into vehicle interior | The long sealing lip of the seal (1) should lay around the paneling (8) all the way around. | |
11 | Check whether seal (1) and rear-wall window (2) are seated correctly inside and outside and correct if necessary | ||
12 | Remove lubricant residues | ||
13 | Install upper bunk | Only on vehicles with code D3A (Deluxe bed, top, wide, adjustable). | |
Vehicles with code F4I (Cab rear panel, with window) |
Referenced documents
- ar9175w7710na Remove/install upper bunk