ar6430s572002ca

Prepare bottom corner pillar reinforcement section

Type ar · topic 64.30 · version 0101 · 2015-06-15

Applies to: Model 415.605/705

Where it sits

Function group 3 Body › 64 Rear wall and rear end › 64.30 Corner paneling — Series 415 (models 605, 705)

EinPAS 35 Body/frame/detachable parts › 35.31 Rear panel/rear end › 35.31.30 Rear panel/rear end — Series 415 (models 605, 705)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.45 column — Series 415 (models 605, 705)

AR64.30-S-5720-02CA

Prepare bottom corner pillar reinforcement section

Model

415.605/705

Prepare bottom corner pillar reinforcement section

S64.30-4563-09

1

Mark cut at bottom corner pillar paneling (1) and cut (area A).

Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

Transfer cut from vehicle.

2

Expose spot welds on lower corner pillar reinforcement (1) and cut out (areas B and C).

Prepare bottom corner pillar reinforcement section

S64.30-4564-09

3

Grind mating surfaces on bottom corner pillar paneling (1) down to bare metal in crosshatched areas.

Sand down spot weld flanges to bare metal on both sides.

4

Remove shavings.

5

Coat insides of spot weld flanges with zinc dust paint.

Prepare bottom corner pillar reinforcement section

S64.30-4565-09

6

Drill holes for MAG welding in side crossmember (2) (areas D and E).

7

Grind mating surfaces on side crossmember (2) down to bare metal in crosshatched areas and around holes (areas D and E).

Sand down spot weld flanges to bare metal on both sides.

8

Remove shavings and drill chips.

9

Coat insides of spot weld flanges with zinc dust paint.