ar6430s572002c

Prepare bottom corner pillar reinforcement section

Type ar · topic 64.30 · version 0100 · 2013-07-04

Applies to: MODEL 415.601/603/703

Where it sits

Function group 3 Body › 64 Rear wall and rear end › 64.30 Corner paneling — Series 415 (models 601, 603, 703)

EinPAS 35 Body/frame/detachable parts › 35.31 Rear panel/rear end › 35.31.30 Rear panel/rear end — Series 415 (models 601, 603, 703)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.45 column — Series 415 (models 601, 603, 703)

AR64.30-S-5720-02C

Prepare bottom corner pillar reinforcement section

MODEL

415.601/603/703

Prepare bottom corner pillar reinforcement section

S64.30-4668-09

1

Mark cut at bottom corner pillar paneling (1) and cut (area A).

Transfer separating from vehicle.

Prepare bottom corner pillar reinforcement section

S64.30-4669-09

2

Grind mating surfaces on bottom corner pillar paneling (1) down to bare metal in crosshatched areas.

Sand down spot weld flanges to bare metal on both sides.

3

Remove shavings.

4

Coat insides of spot weld flanges with zinc dust paint.

Prepare bottom corner pillar reinforcement section

S64.30-4565-09

5

Drill holes for MAG welding in side crossmember (2) (areas D and E).

6

Grind mating surfaces on side crossmember (2) down to bare metal in crosshatched areas and around holes (areas D and E).

Sand down spot weld flanges to bare metal on both sides.

7

Remove shavings and drill chips.

8

Coat insides of spot weld flanges with zinc dust paint.