210 589 12 23 00
129 589 00 27 00
129 589 03 21 00
210 589 11 23 00
Gauge for right taillamp cutout
Gauge for left taillamp cutout
Feeler gauge
Bending iron
201 589 00 27 00
Cross-shaped straightener
Commercially available tools
Number | Designation | |
WH58.30-Z-1003-01A | Electrode miller | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
WE58.40-Z-1001-05A | Two-post lifting platform |
P63.50-0252-09
1 Install rear fender, fasten with clamping pliers and sheet metal screws.
2 Install cross-shaped straightener and gauge for taillamp cutout and fasten
3 Check gap dimensions between rear fender and rear door or trunk lid.
4 MIG weld rear fender
Areas: A -
B -
P63.50-0257-06
5 Spot weld rear fender ()
P63.50-0262-06
P63.50-0268-01
P63.50-0267-01
6 Crimp spot weld flange on left wheelhouse with crimping iron (analog to right side of vehicle).
P63.50-0266-06
7 Fill rear fender in cross-hatched areas with body solder and smooth.
8 Clean all remaining welds with wire brush.