P63.50-3680-07
1 Position metal needle templates or flexible measuring tape at Y-markings (arrows) and scribe separation line at rear fender (1) and cut (areas A and B).
2 Remove section from rear fender (1).
P63.50-3661-09
3 Grind mating surfaces on rear fender (1) down to bare metal in the crosshatched areas.
Grind spot weld flanges down to bare metal on both sides.
4 Coat insides of spot welding flange on rear fender (1) with zinc dust paint.
Observe pretreatment of bonding surfaces.
Following steps 5, 6, 7 are not required when replacing C-pillar.
5 Cut out spot welds on lock striker bracket (2) (area C).
6 Drill through spot welds on lock striker bracket (2) (area D).
7 Remove locking eye bracket (2).