P63.50-3828-08
1 Scribe separating point on rear fender (1) (area H).
When replacing inner C-pillar, separation point in area H is no longer required.
Transfer dimensions from vehicle.
2 Cut rear fender (1) at separation point (area H).
3 Remove section from rear fender (1).
P63.50-3637-07
4 Grind mating surfaces on rear fender (1) down to bare metal in the crosshatched areas.
Grind spot weld flanges down to bare metal on both sides.
5 Coat insides of spot welding flange on rear fender (1) with zinc dust paint.
Do not coat bonding surfaces with zinc dust paint to prevent adhesion problems (areas V, V1, W and X).
Observe pretreatment of bonding surfaces (areas V, V1, W and X).
P63.50-3653-01
6 Grind mating surface on rear fender (1) down to bare metal in crosshatched areas.
7 Coat mating surface on rear fender (1) with zinc dust paint.
To prevent adhesion problems, do not coat bonding surfaces with zinc dust paint.
Observe pretreatment of bonding surfaces.