AR63.10-W-0807-01B | Partially remove side wall in combination with complete side longitudinal member and floor panel |
Spot weld milling cutter
201 589 00 51 00
Commercially available tools
Number | Designation | |
WH58.30-Z-1002-01A | Ball cutter, dia. 12 mm | |
WH58.30-Z-1006-01A | Vario Drill WS 91 spot weld removing tool | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1021-04A | Cutting disk, dia. 65 mm, 80 m/s (max. 23,500 rpm) | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
W63.10-1058-07
1 Cut inner roof frame (2) along dotted lines to reach spot welds below
2 Expose spot welds in areas A and B.
3 Cut out spot welds in areas A and B
4 Remove separated section from inner roof frame (2)
5 Cut side wall (1) along broken line with body saw
W63.10-1096-06
6 Cut floor panel (3) to reach welds below.
7 Remove separated section (10)
W63.10-1055-07
8 Expose spot welds in areas E to H.
9 Cut out spot welds in areas E to H.
10 Separate welds in areas J and K
W63.10-1095-04
11 Separate welds in area L
12 Carefully remove roof bow (4) in
area L to reach welds below.
13 Fasten roof bow (4) with C-clamps on inner roof frame (2)
W63.10-1090-06
14 Expose spot welds in areas M, N, O1 and O2.
15 Cut out spot welds in areas M, N, O1 and O2
16 Separate welds areas P, Q, R1 and R2 with spherical milling cutter
W63.10-1052-06
17 Expose spot welds in areas S to V.
18 Cut out spot welds in areas S to V.
W63.10-1094-09
19 Expose spot welds in areas W to Z and in area AC
20 Cut out spot welds in areas W to Z and in area AC
21 Separate welds on side longitudinal member (8) in connection area to cross member (7) in areas AA and AB with spherical milling cutter.
W63.10-1093-09
22 Expose spot welds in areas AD to AJ
23 Cut out spot welds in areas AD to AJ.
24 Separate welds in areas AK to AN.
W63.10-1092-09
25 Expose spot welds in areas AO and AP
26 Cut out spot welds in areas AO and AP.
27 Separate weld in area AQ.
28 Remove side wall (1), floor panel (3) and side longitudinal member (8)
W63.10-1091-10
29 Expose spot welds in area AS.
30 Cut out spot welds in area AS.
31 Remove remaining flange (20).