Commercially available tools
Number | Designation | |
WH58.30-Z-1003-01A | Electrode miller | |
WH58.30-Z-1003-02A | Clamping pliers | |
WH58.30-Z-1031-02A | C-clamp | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
W63.10-1009-09
1 Install side wall, fit and fasten with clamping pliers.
2 Weld in side wall in illustrated areas with .
W63.10-1007-06
3 Weld in side wall in areas A to D with .
4 Drill 4 mm dia. holes in areas E and F and countersink with 8 mm dia. bit at one side.
Countersink alternately from inside and outside in area E.
5 Weld in side wall in areas E and F with .
Always weld from countersunk side.
6 Weld in side wall in area G with .
7 Grind spot welds down flat in areas A to F
8 Clean all other welds with wire brush.