The following operation steps are shown on the left side of the vehicle. In case of damage on the right side of the vehicle, these steps must be performed analogously.
Additional information can be found in the superordinate service document.
The safety information in the superordinate service document must be observed.
1 | Install rear outer wheel well (1), fit, and fix in place. |
2 | Drill rivet holes on the rear outer wheel well (1) with a diameter of 6.7 mm (areas A). |
3 | Remove rear outer wheel well (1). |
4 | Deburr rear outer wheel well (1) and body on both sides. |
5 | Remove drilling chips. |
6 | Coat insides of the rivet holes with zinc dust paint. |
P63.10-5729-06
7 | Apply 2-component adhesive in cross-hatched areas on body. |
Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive. |
P63.10-5730-12
P63.10-5731-09
8 | Install rear outer wheel well (1), fit, and fix in place. |
9 | Rivet rear outer wheel well l(1) with rivets with a diameter of 6.4 x 12 mm (area B). |
10 | Rear outer wheel well (1) (areas C, D1, D2, E, F, G, H). |
11 | Install connecting panel (2), fit, and fix in place. |
12 | Connecting panel (2) (areas I1, I2, I3, I4). |
P63.10-5732-09
13 | Rivet rear outer wheel well (1) with rivets with a diameter of 6.4 x 12 mm (area K). |
14 | Rear outer wheel well (1) (areas L, M). |