AR63.10-L-0670-06VA | Install rear outer wheel arch panel | ||
| Measures for preventing damage to vehicles or components when performing arc welding work | All models |
Test and adjusting values, gap sizes at hoods, doors and covers
Number | Designation | Models | |||
BE60.00-P-1002-01A | Gap size | Front door to A-pillar | Dimension" B" | mm | 5.0 (0.5) |
Front door and front fender | Dimension "H" | mm | 5.0 (0.5) | ||
Front door and rear door | Dimension" I" | mm | - | ||
Front door to roof | Dimension "C" | mm | - | ||
Rear door and upper side section | Dimension "D" | mm | - | ||
Rear door to lower side section | Dimension" J" | mm | - | ||
Fender to A-pillar | Dimension" Q" | mm | 2.0 (0.5) | ||
Front door to rear fender | Dimension "P" | mm | 5.0 (0.5) | ||
Fig. see | - | ||||
BE60.00-P-1011-01A | Gap size | Rear door to rear light unit | Dimension" G" | mm | 5.0 (0.5) |
Tailgate to bumper | Dimension" I" | mm | 7.0 (0.5) | ||
Tailgate to tailgate | Dimension" L" | mm | 7.0 (0.5) | ||
Tailgate to rear spoiler | Dimension" M" | mm | 5.0 (0.5) | ||
Rear spoiler to roof | Dimension "T" | mm | 7.0 (0.5) | ||
Fig. see | - | ||||
Feeler gage
129 589 03 21 00
Commercially available tools
Number | Designation | |
WH58.30-Z-1003-01A | Electrode miller | |
WH58.30-Z-1003-02A | Clamping pliers | |
WH58.30-Z-1031-02A | C-clamp | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
L63.10-0094-09
1 Fasten wheelhouse with sheet metal screws and fit together with side wall (areas A-C).
2 Check gaps
3 Remove side wall again
4 Wheelhouse in area D .
5 Clean all welds with wire brush.
Referenced documents
- ah0000n000501a Measures for preventing damage to vehicles or components when performing electric welding work