Separate right side wall paneling

AR63.10-D-5886-01FA

Separate right side wall paneling

 Warning

Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.

Wear protective gloves, protective clothing and safety glasses, if necessary.

AS00.00-Z-0002-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

General information on body repair

AH60.00-N-0001-01A

Model

909.6

with code T16 (Sliding door right)

Model

909.843

with code T16 (Sliding door right)

except code W03 (Body extension)

1.1

Model 909.6
with code T16 (Sliding door right)
Carefully heat side wall seatbelts (2) and side wall reinforcements (3) in load compartment and loosen adhesive joints to side wall paneling (1).

 The side wall paneling (1) is bonded in the area of the side wall seatbelts (2) and side wall reinforcements (3).

1.2

Model 909.843
with code T16 (Sliding door right)
except code W03 (Body extension)
Carefully heat side wall seatbelts (3) in load compartment and loosen adhesive joints to side wall paneling (1).

 The side wall paneling (1) is bonded in the area of the side wall reinforcements (3).

Shown on model 909.6 with code T16 (Right sliding door)

2

Expose spot welds on side wall paneling (1) and cut out with  spot weld milling cutter (areas A and B).

3

Expose spot welds on side wall paneling (1) and cut out with  spot weld milling cutter (area C).

4

Mark separating points on side wall paneling (1) and cut (areas D).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

5

Mark separating points on side wall paneling (1) approx. 1 mm in front of beaded edge and cut (areas E and F).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

6

Remove side wall paneling (1).