ar6310d565403ts

Install center bottom sidewall paneling and weld in

Type ar · topic 63.10 · version 0100 · 2017-12-14

Applies to: Model 907.6/7, 910.6

Where it sits

Function group 3 Body › 63 Side wall › 63.10 Side wall — Series 907 (models 6**, 7**) · Series 910 (models 6**)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.35 Fender/sidewall — Series 907 (models 6**, 7**) · Series 910 (models 6**)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.38 Left panel — Series 907 (models 6**, 7**) · Series 910 (models 6**)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.39 Right panel — Series 907 (models 6**, 7**) · Series 910 (models 6**)

AR63.10-D-5654-03TS

Install center bottom sidewall paneling and weld in

Danger

The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases

Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.

AS00.00-Z-0007-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Measures for preventing damage to vehicles or components when performing electric welding work

AH00.00-N-0005-01A

000 588 01 84 00 Welder

WS60.00-P-0021K

000 588 02 84 00 Welder

WS60.00-P-0022K

Model

907.6/7, 910.6

Repair materials

Number

Designation

Order number

BR00.45-Z-1107-01A

Black seam seal 300 ml

A 005 989 63 20

The following operation steps are shown on model 907.633 with code D03 (Roof and rear-end doors, high version) on the left side of vehicle and must be performed analogously on the right side of vehicle if damaged.

Install center bottom sidewall paneling and weld in

1

Apply seam seal in hatched area.


D63.10-1942-04

Install center bottom sidewall paneling and weld in

D63.10-1943-09

2

Install, align and fix center bottom sidewall paneling (1) into place.

3

Lower center side wall paneling (1) (area H).

4

Tack weld lower center side wall paneling (1) (area F).

5

Lower center side wall paneling (1) (area G).

6

Face-grind inert gas tack welds and inert gas spot welds (areas F and G).

7

Remove shavings.

Install center bottom sidewall paneling and weld in

8

Lower center side wall paneling (1) (area I).


D63.10-1944-05

Referenced documents