ar6110d003003h

Install rear entrance box.

Type ar · topic 61.10 · version 0100 · 2006-08-14

Applies to: MODEL 906.2

Where it sits

Function group 3 Body › 61 Substructure › 61.10 Frame floor system — Series 906 (models 2**)

EinPAS 35 Body/frame/detachable parts › 35.20 Cab/body › 35.20.50 Entrance — Series 906 (models 2**)

EinPAS 35 Body/frame/detachable parts › 35.32 Substructure › 35.32.35 floor assembly/substructure frame — Series 906 (models 2**)

AR61.10-D-0030-03H

Install rear entrance box.

Commercially available tools

Number

Designation

WH58.30-Z-1003-01A

Electrode miller

WH58.30-Z-1003-02A

Clamping pliers

WH58.30-Z-1001-03A

Round wire brush, braided, dia. 70 mm

WH58.30-Z-1024-04A

Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm)

Workshop equipment

WE58.40-Z-1001-02A

Inert gas welder

WE58.40-Z-1002-02A

Spot welder

WE58.40-Z-1001-03A

Drill (electric/pneumatic)

WE58.40-Z-1003-03A

Angle grinder (electric/pneumatic)

WE58.40-Z-1005-03A

Wet/dry vacuum cleaner

Install rear entrance box.

D61.10-1297-09

The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.

1 Install rear entrance box (1), fit and fasten using clamping pliers.

2 Drill 7 mm dia. pilot holes in rear entrance box (1) (areas D and G).

3 Rear entrance box (1) (areas B, C, D, E, F, G, H and I).

4 Rear entrance box (1) (area A).

5 Clean weld joints on rear entrance box (1) using round wire brush.

6 Remove grinding and drill shavings using wet/dry vacuum cleaner.