Tilt cab to repair position, tilt back

AR60.80-G-0010B

Tilt cab to repair position, tilt back

1.9.09

 Danger!

Risk of injury caused by body parts being pinched or crushed as cab is tilted

Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut.

AS60.80-Z-0001-01A

1

Remove engine hood and front paneling

 See the Operator's Manual .

2

Remove bolt (1)

 On left and right in footwell.
Do not unscrew bolt (1) on left. Use bolt (1) to fasten safety strut (9).



*BA60.80-N-1002-01A

3

Remove bolt (2)

 Completely move front passenger seat toward rear.



*BA60.80-N-1002-01A

4

Unlock locating pin on tilt support (3) and remove

 Left and right side of vehicle

5

Close tilt support (3), install locating pin and secure

 Left and right side of vehicle

6

Loosen intake hose (4) from air filter and remove

 Close both openings.

7

Pull both heater hoses (8, 9) out of bracket

 On vehicles with special equipment, remove electric, hydraulic, pneumatic lines and Bowden cables and weld.

 Tilt back: Check oil levels.

8

Check oil level in hydraulic pump

 See the Operator's Manual .

9

Close locking valve on cylinder of hydraulic pump

 Tilting back: Open again locking valve only after titling back. The locking valve must always be open while driving, in order to maintain correct pressure compensation of torsion.

10

Position pump lever on hydraulic pump to "Raising" position

 Tilting back: Move pump lever to "Lowering" position.

11

Insert extension tube into hydraulic pump and slowly pump up cab.

 Install fastening strap (5) while pumping up.



Notes on tilting the cab

Model 405, 408, 418, 427, 436.330, 437

AH60.80-N-0003-01B

12

Fasten suitable safety rope (6) with shackles to cab and frame

 Install safety rope (6) so that cab does not tilt beyond dead center position.

13

Carefully continue to pump up cab.

 Lift cab only until safety strut (5) can be installed

14

Install suitable safety strut (5)

15

Lower in reverse sequence

 Tilting back: When tilting back the cab, ensure that a second person slides the steering shaft (10) into the sliding piece from front (Caution: Danger of pinching). Observe markings. Grease steering shaft (10) and sliding piece.
Ensure that leads, hoses, etc. have sufficient clearance.

Number

Designation

Model
427

Model
437 without body 425.840/845

BA60.80-N-1002-01A

Cab to frame and to body member

Nm

210

210