Partially remove/install detachable parts on entrance for replacing longitudinal member

AR60.00-S-0022P

Partially remove/install detachable parts on entrance for replacing longitudinal member

02.09.2019

Model

470, 471

Front left area

Modification notes

09.05.2019

Method extended

Operation step 7

Shown on model 470 with engine 699

1

Screw

2

Bracket

3

Bolts

6

ISOFIX child seat attachment

7

Bolts

8

Seat belt retractor bracket

9

Cover

10

Bracket

Potential cuts for repair variants

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Remove edge guard for door cutout of front door.

2

Remove lower C-pillar trim.

AR68.30-S-4494P

3

Remove front door.

AR72.10-S-0500P

4

Remove lower front door hinge.

For "variant 2" (cuts in areas A and C) or "variant 11" (cuts in areas A and B).

AR72.10-S-2662P

5

Remove front fender.

For "variant 2" (cuts in areas A and C) or "variant 11" (cuts in areas A and B).

AR88.10-S-1005P

6

Remove side running board.

Model 470, 471
with code T1A (Side running boards, left and right)

AR88.30-S-2400P

7

Remove side bar with step.

Model 470, 471 with code Y1M (side bar with step) or with code Y1N (side bar with step)

AR88.30-S-0014P

8

Remove floor mats.

9

Remove front seat.

AR91.10-S-1000P

10

Disconnect electrical connector from exhaust aftertreatment system control unit.

Model 470 with engine 642, model 470 with engine 699 except code MT2 (emissions class Euro 6d-TEMP N1 GR.III/N2)

AR14.40-S-2077PD

11

Remove screw/bolt (1).

12

Remove holder (2).

Model 470 with engine 642, 699

 To do this, remove screws/bolts (3).

13

Remove ISOFIX child seat securing system (6).

 To do this, remove bolts (7).

 Screw, ISOFIX child seat securing system to vehicle floor

*BA91.40-N-1013-01P

14

Remove bracket for seat belt retractor (8) of seat belt in rear from rear panel and vehicle floor.

AR91.40-S-0682P

15

Remove cap (9).

16

Remove bracket (10).

 Clip remover

*452589016300

17

Move floor covering out of working area.

18

Remove electrical subharnesses.

 Installation: Refasten electrical subharnesses.

19

Route electrical subharnesses out of working area.

20

Install in the reverse order.

 Seat belts/emergency tensioning retractors

Number

Designation

Model 471

Model 470

BA91.40-N-1013-01P

Screw, ISOFIX child seat securing system to vehicle floor

Nm

45

45