Test and adjustment values for gap dimensions
Number | Designation | Model 251 | |||
BE60.00-P-1001-01S | Gap dimension | Lamp unit to engine hood | Dimension "A" | mm | 4 (1) |
Lamp unit to fender | Dimension "B" | mm | 4 (1) | ||
Lamp unit to bumper | Dimension "C" | mm | 4 (1) | ||
Engine hood to bumper | Dimension "D" | mm | 6 (1) | ||
Engine hood to front grille/bumper to front grille | Dimension "E" | mm | 7 (1) | ||
See figure in | - | ||||
BE60.00-P-1002-01S | Gap dimension | Fender/engine hood | Dimension "F" | mm | 3.5 (1) |
Engine hood to A-pillar | Dimension "G" | mm | 3.5 (1) | ||
Fender to A-pillar | Dimension "H" | mm | 3.5 (1) | ||
Front fender to front door | Dimension "I" | mm | 4 (1) | ||
Front door to A-pillar | Dimension "J" | mm | 4 (1) | ||
See figure in | - | ||||
BE60.00-P-1003-01S | Gap dimension | Front door to rear door in area of B-pillar | Dimension "K" | mm | 4.5 (1) |
Rear door to roof frame | Dimension "L" | mm | 4 (1) | ||
Rear door to C-pillar | Dimension "M" | mm | 4.5 (1) | ||
Rear-end door to side wall | Dimension "N" | mm | 5.5 (1) | ||
Rear-end door glass to side wall | Dimension "O" | mm | 5.5 (1) | ||
See figure in | - | ||||
BE60.00-P-1004-01S | Gap dimension | Rear-end door to side wall | Dimension "P" | mm | 5.5 (1) |
Rear door to rear fender | Dimension "Q" | mm | 4 (1) | ||
Rear door to door sill molding | Dimension "R" | mm | 6 (0.5) | ||
Front door to rear door | Dimension "S" | mm | 4 (1) | ||
Front door to door sill molding | Dimension "T" | mm | 5 (0.5) | ||
See figure in | - | ||||
BE60.00-P-1005-01S | Gap dimension | Taillamp to bumper | Dimension "U" | mm | 3,5 (1.5) |
Taillamp to side wall | Dimension "V" | mm | 3.5 (1) | ||
Dimension "W" | mm | 4 (1) | |||
Taillamp to rear-end door | Dimension "X" | mm | 4.5 (1.5) | ||
Rear-end door to antenna module | Dimension "Y" | mm | 5.5 (0.5) | ||
Rear-end door to bumper | Dimension "Z" | mm | 6 (1.5) | ||
See figure in | - | ||||
Feeler gauge
129 589 03 21 00
P60.00-2687-09
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2688-06
P60.00-2689-09
P60.00-2690-09