ar5550t0600a

Removing and installing bellows

Type ar · topic 55.50 · version 0101 · 2005-07-12

Applies to: MODEL NMB671.312 /322 /327 /332 /333

Where it sits

Function group 2 Chassis › 55 Auxiliary drive systems, hydraulic and linkage systems › 55.50 Linkage systems — Series 671 (models 312, 322, 327, 332, 333)

EinPAS 35 Body/frame/detachable parts › 35.55 Articulation system/turntable › 35.55.50 Boot — Series 671 (models 312, 322, 327, 332, 333)

AR55.50-T-0600A

Removing and installing bellows

23.11.98

MODEL NMB671.312 /322 /327 /332 /333

Removing and installing bellows

T55.50-0003-06

1 Center bow

2 Guide rod

3 Bolt

4 Retaining strip

5 Locking belt

8 Bellows

Removing

1

Park vehicle in straight-ahead position over a pit

2

Remove protective cover over locking belt (5)

3

Remove locking belt (5)

4

Unscrew bolts (3)

5

Remove retaining strips (4)

6

Carefully pull tabs of bellows (8) off vehicle floor

The tabs of the bellows (8) are affixed to the vehicle floor with double-sided adhesive strips.

7

Open cable lock

AR55.50-T-0600-02A

8

Remove guide rods (2)

The guide rods (2) are located between the turntable and the bellows (8).

9

Unhook bellows (8) from guides on front/rear section and center bow (1)

Tie bellows (8) together.

10

Remove bellows (8)

Installing

11

Attach bellows (8) to guides on front/rear section and center bow (1)

Align bellows (8).

12

Close cable lock

AR55.50-T-0600-01A

13

Stick tabs of bellows (8) onto vehicle floor

Replace the double-sided adhesive strips if necessary.

14

Install retaining strips (4)

15

Install locking belt (5)

16

Install protective cover over locking belt (5)

17

Install guide rods (2)

Attach eyelets of bellows (8) to guide rods (2).

Referenced documents