ar5465s0002a

Removing and installing Parktronic System (PTS) sensors in rear bumper

Type ar · topic 54.65 · version 0100 · 1999-01-27

Applies to: MODEL 638.0 /1 /2 with CODE (J44) ultrasonic backup assist

Where it sits

Function group 2 Chassis › 54 Electrical system, equipment and instruments › 54.65 Parking assist — Series 638 (models 0**, 1**, 2**)

EinPAS 28 Convenience system/driver assistance system › 28.15 Parking Assist › 28.15.12 Sensor/switch/wiring harness — Series 638 (models 0**, 1**, 2**)

AR54.65-S-0002A

Removing and installing Parktronic System (PTS) sensors in rear bumper

23.9.98

MODEL 638.0 /1 /2 with CODE (J44) ultrasonic backup assist

Removing and installing Parktronic System (PTS) sensors in rear bumper

S54.65-2515-06

1 Bumper

2 Electric cable

3 Clamp ring

4 Woodruff key

5 Sensor

6 Edge of sensor

Removing, installing

1

Remove bumper (1) and disconnect connectors

When removing the bumper ensure that the electric cable (2) of the sensors is not damaged.

AR88.20-S-2200A

2

Turn clamping ring (3) through 90° and pull off

Installation: Push clamping ring onto sensor (5) in the as installed position and engage against the spring force with slight pressure

3

Remove woodruff key (4)

Installation: Pay attention to correct installed position of woodruff key!

4

Remove sensor (5)

Installation: The edge of the sensor (6) must have its widest point downwards. The connection for the connector must point to the right on the inside of the bumper.

5

Install in reverse order

Referenced documents