Removing and installing Parktronic System (PTS) sensors in rear bumper

AR54.65-P-0002B

Removing and installing Parktronic System (PTS) sensors in rear bumper

19.3.98

 

Removing, installing

1

Remove rear bumper

ra88001400220x

2

Remove damper elements

 Regardless of which sensor is to be removed.

3

Disconnect electrical connector (2) on Parktronic system sensor (1)

4.1

Remove sensor (1) from Parktronic sensor support (3) in direction of arrow

Models 140.1, 140.02, 140.03, 140.04, 140.05

To do this, use the special tool to spread the retaining lugs on the sensor support from the inside of the bumper while pushing the sensor from the outside in the direction of the arrow



*140589063100



*140589050900



*001589812100



*BA54.65-P-1001-01A

If sensor support is defective:

Replace Parktronic sensor support

AR54.65-P-0002-01A

4.2

Remove sensor (1) from Parktronic sensor support (3) in direction of arrow

Models 140.06, 140.07

To do this, use the special tool to spread the retaining lugs on the sensor support from the inside of the bumper while pushing the sensor from the outside in the direction of the arrow



*140589063100

If sensor support is defective:

Unclip spring clips on sensor housing and remove sensor housing with insulation disk

5

Install in the reverse sequence

6

Perform function test

Number

Designation

Model 140

BA54.65-P-1001-01A

Union nut to sensor support

Nm

2.5