ar5430p6341ea

Removing and installing outside temperature indicator sensor

Type ar · topic 54.30 · version 0106 · 1999-11-26

Applies to: MODEL 202, 210 up to 30.5.96 with CODE (240a) Outside temperature indicator

Where it sits

Function group 2 Chassis › 54 Electrical system, equipment and instruments › 54.30 Instrument cluster, display instruments, hazard warning device — Series 202 · Series 210

EinPAS 31 Communication/information/entertainment › 31.30 Instrument cluster/onboard computer › 31.30.12 Sensor/switch/wiring harness — Series 202 · Series 210

EinPAS 39 Heating/ventilation/cooling › 39.15 Climate control › 39.15.12 Sensor/switch/wiring harness — Series 202 · Series 210

AR54.30-P-6341EA

Removing and installing outside temperature indicator sensor

5.5.94

MODEL 202, 210 up to 30.5.96 with CODE (240a) Outside temperature indicator

Removing and installing outside temperature indicator sensor

P54.30-0218-06

1 21-pin connector (model 202)
1 25-pin connector (model 210)
2 Temperature sensor wiring harness
A1 Instrument cluster

B14 Outside temperature indicator temperature sensor

F1 Fuse and relay box

The figure shows the routing of the wires in the model 202 sedan. The schematic for the wire routing and location of the components is also applicable for model 210 and the T-model.

Removal

Outside temperature indicator sensor Location / Function

GF54.30-P-4104A

1

Disconnect ground lead from battery

On model 210 insulate the ground lead with cable terminal to prevent unintentional contact between disconnected ground lead and ground point W10

AR54.10-P-0003A

2

Unclip fuse boxes or fuse blocks in fuse and relay box (F1) and remove

3

Remove cover below instrument panel (driver's side)

Model 202

AR68.10-P-1500E

Model 210

AR68.10-P-1500F

4

Remove instrument cluster (A1)

AR54.30-P-6015EA

5.1

Open installation flap for left fog lamp

Model 210

6.1

Unclip outside temperature indicator temperature sensor (B14) below front bumper and tie back

Model 202

Wiring harness with temperature sensor remains in vehicle

6.2

Unclip outside temperature indicator temperature sensor (B14) in installation compartment for left fog lamp and tie back

Model 210

Wiring harness with temperature sensor remains in vehicle

7

Open 21-pin or 25-pin connector (1) for instrument cluster (A1), disconnect coding section A (wire color code A1 green and A2 brown) from connector strip, insulate and tie back

Installation

8

Guide wiring harness (2) for new outside temperature indicator temperature sensor (B14) through fuse and relay box (F1), route parallel to left headlamp wiring harness and fasten

9

Clip in outside temperature indicator temperature sensor (B14)

On model 202 tie excess length on new wiring harness back into wiring duct and on model 210 tie back into installation compartment for left fog lamp

10.1

Close installation flap for left fog lamp

Model 210

11

Connect coding section A (wire color code A1 green and A2 brown) to connector strip and close 21-pin or 25-pin connector

12

Reinstall instrument cluster (A1)

AR54.30-P-6015EA

13

Reinstall cover below instrument panel

Model 202

AR68.10-P-1500E

Model 210

AR68.10-P-1500F

14

Clip fuse boxes or fuse blocks into fuse and relay box (F1)

15

Reconnect ground lead to battery

AR54.10-P-0003A

Referenced documents