ar5425d4001ts

Remove/install start/stop button

Type ar · topic 54.25 · version 0100 · 2018-05-04

Applies to: Model 907, 910

Where it sits

Function group 2 Chassis › 54 Electrical system, equipment and instruments › 54.25 Switches — Series 907 · Series 910

EinPAS 29 Drive authorization/security system › 29.25 Drive authorization › 29.25.12 Sensor/switch/wiring harness — Series 907 · Series 910

AR54.25-D-4001TS

Remove/install start/stop button

22.11.2017

Model

907, 910

Remove/install start/stop button

D54.25-1127-09

1

Start/stop button

3

Screw

2

Cover

4

Cover

Remove/install start/stop button

D54.25-1128-09

1

Start/stop button

6

Bracket

5

Retaining tabs

7

Electrical connector

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Switch off ignition and store transmitter key outside of transmission range (min. 2 m)

2

Release trim (2) and remove with attached electric lines from working area

AR68.10-D-0001TS

3

Remove bolts (3)

4

Remove cover (4)

5

Release start/stop button (1) at retaining tabs (5) and push in direction of arrow (arrow A) out of holder (6) and into instrument panel

WIS Service Media
wsm://04_ 201710_02

6

Route start/stop button (1) through the opening in the instrument panel until the electrical connector (7) is accessible

7

Disconnect electrical connector (7) and remove start/stop button (1)

8

Install in the reverse order

Check

9

Perform function test of start/stop button (1)

Referenced documents