S47.40-A000-79
1 | Exhaust aftertreatment system control unit | 3 | Electrical connector | 4 | Bracket | ||
2 | Electrical connector |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Switch off the ignition and keep the transmitter key outside the transmitter range (at minimum 2m). | ||
2 | Bring steering column into the uppermost position | ||
3 | Remove left cover under the dashboard | ||
4 | Remove exhaust gas aftertreatment system control unit (1) from the bracket (4) and remove in the direction of the arrow until the electrical connectors (2, 3) are accessible. | ||
5 | Disconnect electrical connectors (2, 3) and remove exhaust gas aftertreatment system control unit (1). | ||
6 | Install in the reverse order. | ||
7 | Fill NOx reducing agent tank. | If a new exhaust gas aftertreatment system control unit (1) is installed. | |
8 | Enter fill level of the NOx reducing agent tank in the exhaust gas aftertreatment system control unit (1). | If a new exhaust gas aftertreatment system control unit (1) is installed. | |
| |||
9 | Read out and delete fault memory. | If a new exhaust gas aftertreatment system control unit (1) is installed. | |
|
Referenced documents
- ad0000s200004e Connect STAR DIAGNOSIS and read out fault memory
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- ah6800n000101s Notes on carrying out repair work in the vehicle interior
- ar4920s2015ea Empty/fill AdBlue(R) tank
- ar6810s1500e Remove/install cover below instrument panel (left)