AR46.10-W-0900A | Remove/install steering wheel lock | 24.2.12 |
MODEL 374, 375, 930, 932, 933, 934, 940, 942, 943, 944, 950, 952, 953, 954, 958, 970, 972, 974, 975, 976
W46.10-1010-12
1 Steering lock
2 Transponder coil
3 Shear-off screws
4 Electrical line
5 Shear-off screw (new)
Modification notes
| Remove/install | ||
| Notes on working on the steering system in vehicles with airbag | ||
1 | Switch off ignition | ||
2 | Disconnect ground lead from battery | ||
3 | Detach cover from steering column | ||
4 | Expose electrical lines (4) of combination switch | ||
5 | Remove transponder coil (2) from steering lock (1) | Installation: Note installation position. | |
6 | Drill out stumps of shear-off screws (3) on steering lock (1) | Pre-drill with a 3 mm dia. drill bit, then expand with an 8 mm dia. bit. Do not damage electric leads (4). | |
Installation: Tighten the new shear-off screws (5) evenly until the bolt heads shear off. | |||
7 | Remove right footwell cover on driver side | ||
8 | Remove steering lock (1) from steering column and disconnect electrical connector above accelerator pedal | ||
9 | Remove lock cylinder | Only when steering wheel lock (1) is to be replaced. | |
10 | Install in the reverse order |
Referenced documents
- ah4600n000101a Notes on working on the steering system in vehicles with airbag
- ar4610w0801a Remove/install lock cylinder on steering wheel lock
- ar5410w0003a Disconnect/connect battery ground line