ar4610b0801a

Remove/install lock cylinder on steering wheel lock

Type ar · topic 46.10 · version 0101 · 2020-02-06

Applies to: Steering gear 766.565

Where it sits

Function group 2 Chassis › 46 Steering › 46.10 Steering wheel, jacket tube, steering shaft, steering lock

EinPAS 22 Steering › 22.15 Power steering › 22.15.40 Steering wheel/steering column/steering column tube/steering lock

Also applies to engines/gearboxes: 766 565

AR46.10-B-0801A

Remove/install lock cylinder on steering wheel lock

20.01.2020

Steering gear

766.565

Remove/install lock cylinder on steering wheel lock

1

Transmitter Coil

S1

Steering contact and start up shut-off device

W54.25-0003-01

Remove/install lock cylinder on steering wheel lock

2

Closing Cylinder (lock core)

3

Cylinder ring

W54.25-0004-01

Remove/install

1

Disconnect the contact and starter switch.

Danger

Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC.

No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

2

Disconnect battery ground cable

Topical note

Notes on battery

AH54.10-P-0001-01A

3

Remove the steering wheel.

AR46.10-B-0100C

4

Remove the floor coverage from clearance in the left side to the driver foot.

AR68.30-B-1310B

5

Remove the steering wheel covering.

6

Remove the response transmitter coil (1) from the contact and starter switch (S1).

7

Put the contact and start up switch in position 2.

8

With the key, move the closing cylinder (lock core) approximately 2 mm to position 1.

Keep the key in this position.

9

Perform turning movements to the left and right. Remove the ring (3) from the insert.

Installation: In the installing procedure, it is necessary to pay attention when installing the ring together with the closing cylinder (lock core).

10

Remove the closing cylinder (lock core) (2) together with the key, from its housing in the steering set.

Installation: When disassembling the closing cylinder (lock core) (2) the insert at the bottom of the case (gear switch) may bent. If the groove is turned, use a screwdriver to turn it to position 2, and then return it approximately 2 mm to position 1.

11

Remove the key and the ring (3) from the closing cylinder (lock core) (2).

12

Perform the assembly in reverse order.

Referenced documents