Change tires on wheels

AR40.10-G-0010B

Change tires on wheels

24.09.2018

Model

405.050/100/101/102/103/120/121/122/123/200/201/220/221

Modification notes

18.09.2018

Work procedure completely revised.

10

Coding plug

A29

Tire pressure control system control unit (with code A30 (Tire pressure control system (tire control)))

 Danger

Risk of death caused by vehicle slipping or toppling off during lifting

Only lift vehicle at the lift support points specified by the vehicle manufacturer.

AS00.00-Z-0032-01A

Notes on pinning and unpinning electric lines in connector housings and plug housings

AH54.00-N-1453-01A

Change tires on wheels

1

Remove front and rear wheels.

AR40.10-G-1100F

2

replace the tire.

 Use permissible tire models only, see axle loads and the operator's manual for the vehicle.

3

Adjust tire pressure.



AP40.15-G-4060B

4

Note maximum set tire pressure.

Only for vehicles with code A30 (Tire pressure control system (tire control))

5

Balance front and rear wheels.

6

Attach front and rear wheels.

AR40.10-G-1100F

7

Connect diagnostic system and start XENTRY.



AD00.00-G-2000-04B

8

Read out and delete fault memory.

9

Check tire size of mounted tires in ABS control unit (4-channel) (A10/1).

If there is a deviation in tire size:



Change tire size in ABS control unit (4-channel) (A10/1).

10

End XENTRY and remove the diagnostic system.

11

Print out coding plug table for maximum tire pressure.

Only for vehicles with code A30 (Tire pressure control system (tire control))



AP40.15-G-4060-04BC

12.1

Open electronics compartment at the top right of the instrument panel.

Model 405.0 with code A30 (Tire pressure control system (tire control))

12.2

Open electronics compartment behind front passenger seat.

Model 405.1/2 with code A30 (Tire pressure control system (tire control))

13

Check pin assignment in coding plug (10) at RDR control unit (A29) and compare with "Coding plug table for maximum tire pressure" and noted-down tire pressure.

Only for vehicles with code A30 (Tire pressure control system (tire control))

If deviations in pin assignment are present:



Correct pin assignment in coding plug (10).

 When correcting the pin assignment, use  wiring harness repair kit supplement for trucks or  basic wiring harness repair kit.

 Wiring harness repair kit, basic

*000589139900

 Supplemental truck wiring harness repair kit

*930589009900

14.1

Close electronics compartment at the top right of the instrument panel.

Model 405.0 with code A30 (Tire pressure control system (tire control))

14.2

Close electronics compartment behind front passenger seat.

Model 405.1/2 with code A30 (Tire pressure control system (tire control))



Measure

15

Measure wheel angle.

AR40.20-G-0345B