ar3530d045805a

Preparing drive bevel gear for installing

Type ar · topic 35.30 · version 0101 · 1998-06-05

Applies to: REAR AXLE 742.5 /4

Where it sits

Function group 2 Chassis › 35 Rear axle › 35.30 Final drive, drive shafts

EinPAS 17 Drivetrain/axle › 17.51 Rear axle › 17.51.65 Rear axle differential/axle through-drive

Also applies to engines/gearboxes: 742 4**, 742 5**

AR35.30-D-0458-05A

Preparing drive bevel gear for installing

Clamp for clamping assembled drive pinion

WF58.50-N-3530-05B

Preparing drive bevel gear for installing

Puller

745 589 00 33 00

Preparing drive bevel gear for installing

D35.30-0121-01

1 Place clamp (16) around the tapered roller bearing outer races and clamp drive pinion in vise.

2 Attach puller (17) to drive flange (9) with two hexagon bolts (18) so that the hexagon bolts exert a force of approx. 30 Nm on the ring nut (10) and the puller (17) abuts flat with the drive flange (9).

This tensions the tapered roller bearing outer races axially and the spacing washer halves cannot slip into the oil groove when pulling out the drive pinion.

Preparing drive bevel gear for installing

D35.30-0120-01

1 Drive pinion 12 Spacer ring

2 Crown wheel 13 Spacing washer halves

3 Inner tapered roller bearing 14 Spacer disks

4 Outer tapered roller bearing 15 Cylindrical roller bearing

5 Tab washer

6 Spacer disk

7 Radial seal ring

8 Collared nut

9 Drive flange

10 Ring nut

11 Ring nut oil groove

Referenced documents