1 | Fastening screws |
2 | Flange of the axle shaft |
3 | Semi-shaft |
B35.30-A008-11
| Remove | ||
1 | Remove the fastening screws (1) from flange of the axle shaft (2) | ||
2 | Remove the axle shaft (3) | If there is some difficulty to detach the axle shaft (3): | |
| |||
Apply a few blows using a bronze mandrel and a hammer. | |||
To prevent oil from flowing from the axle to the ground: | |||
| |||
Use an oil collection try. | |||
| Check | ||
3 | Check the splines of the axle shaft (3) | If there is cracks or other irreparable damages: | |
| |||
The axle shaft (3) should be replaced. | |||
In case of roughness or burrs: | |||
| |||
Roughness or burrs should be removed with a file or abrasive stone. | |||
| Clean | ||
4 | Remove the dirt from the splines of the axle shaft (3) | | |
| Install | ||
5 | Apply silicone on junction surface of the axle shaft flange (2) with the wheel hub, and around the fastening screws (1) | Clean the surface of the axle shaft flange (2) and of the wheel hub. | |
The dirt in the parts can impede the action of the sealing silicone. | |||
Prevent that the silicone enters the wheel hub. | |||
Neutral silicone | |||
6 | Install the axle shaft (3) in the rear axle | If there is some difficulty for installing the axle shaft: | |
| |||
Remove the axle shaft (3) again, and repeat the procedure from the work step 3 onward. | |||
7 | Install the fastening screws (1) | Axle shaft mounting screw to wheel hub |