746 589 00 43 00
Insertion tool
W35.30-1207-11
Use the following individual tools of the installing tool set to install the radial shaft sealing ring:
Assembling sleeve (2), with the end number 02;
Pressure spindle (3), with the end number 03;
Counter nut (4);
Threaded bushing (5), with the end number 05;
Pressure piece (6), with the end number 06.
Installation of the tool |
1 | Install the pressure spindle (3) up to the threaded end (A) in the assembling sleeve (2), and in this position, lock the pressure spindle with the counter nut (4). |
W35.30-1203-10
2 | Install the assembling sleeve (2) with the pressure spindle (3) up to the stop on the pinion shaft (11) in the differential housing (8), and then, loosen the assembling sleeve (2) 1/4 turn. |
W35.30-1204-02
Installation of the flange |
3 | Install the flange (9) on the pinion shaft (11) at the differential housing (8). |
4 | Install the pressure piece (6) by means of the pressure spindle (3) on the flange (9). |
5 | Install the threaded bushing (5) on the pressure spindle (3) up to the stop on the pressure piece (6). |
6 | Install the screws (10) on the flange (9) and protect them from falling. |
After installing the flange (9) under pressure, there will not be possible anymore to install the screws (10). |
W35.30-1209-02
7 | Using proper tools, turn the threaded bushing (5) clockwise, avoiding, at same time, turning the pressure spindle (3) |
The flange (9) must touches on the tapered roller bearing of the pinion. |
8 | Remove the threaded bushing (5), the pressure piece (6), and the assembling sleeve (2) with the pressure spindle (3). |
W35.30-1210-02