1 | Taper roller bearing |
2 | Satellite box cover |
3 | Stop washer |
4 | Planetary gear |
5 | Pressure washer |
6 | Satellite gear |
7 | Crosshead |
8 | Planetary gear |
9 | Stop washer |
10 | Ring gear |
11 | Satellite box |
12 | Taper roller bearing |
13 | Satellite box screw |
14a | Crown fastening screw |
B35.31-0048-06
| Disassemble | ||
1 | Remove the ring gear with the differential case from the rear axle | ||
Lifting device | |||
2 | Remove the tapered roller bearings (1, 12) from the differential casing | ||
Puller, two-arm | |||
Thrust element | |||
3 | Disassemble the ring gear () from the differential casing | ||
Mount | |||
4 | Disassemble the differential | ||
| Check | ||
5 | Wash the parts and check for wear | If the self-locking screws are to be reused, clean their locking surface using a wire brush, and remove any burrs from the seating surface at the differential case. | |
Lubricate the parts during the assembly. | |||
If the components are worn: | |||
| |||
Replace the damaged component. | |||
| Assemble | ||
6 | Install the differential | ||
.Differential carrier cover bolt | |||
Mount | |||
7 | Install the ring gear (10) on the differential casing | ||
.Bolt attaching the ring gear to the differential carrier | |||
8 | Install the tapered roller bearings (1, 12) on the differential casing | ||
9 | Install the ring gear with the differential case in the rear axle | ||
Lifting device |
337 589 02 31 00
Mount
314 589 00 63 00
Thrust element
000 589 88 33 00
Puller, two-arm
055 589 16 59 00
Lifting device
Referenced documents
- ar3530b0464e Remove/install crown wheel with differential
- ar3530b430002a Disassemble differential gear
- ar3530b430003a Assembling differential
- ar3530b430004a Detach/attach ring gear at differential case
- ar3530b430005a Install tapered roller bearings on differential housing
- ar3530b430101a Detach tapered roller bearings from differential case