B35.10-0009-09
1 | Vent hose | 10 | Torsion bar clamp | |
2 | Parking brake cable | 11 | Rubber pad | |
3 | Upper guide plate | 12 | Nut | |
4 | Spring U-bolt | 13 | Shock absorber | |
5 | Nut | 14 | Wear indicator | |
6 | Screw | 15 | Electrical wiring | |
7 | Clamp | 16 | Hydraulic pipe | |
8 | Propeller shaft | 17 | Clamp | |
9 | Screw | 18 | Connection |
| Remove/install | ||
1 | Remove the rear wheels |
| |
2 | Drain the oil from the rear axle housing | ||
| . | ||
3 | Release the clamp and remove the vent hose (1) on the axle side | ||
4 | Disconnect the sensor and remove the screw from the brake linings wear indicator cable plug (14) | Installation: Install the new screw. | |
5 | Cut the clamps (17) that secure the electrical wiring (15) of the brake linings wear indicator and move the wiring away from the axle | ||
6 | Loosen the parking brake cable (2) on each side of the axle. | Installation: Adjust the parking brake. | |
7 | Release the lower eyes of the shock absorbers (13), the torsion bar clamp (10) and the rubber pad (11) from the supports | Check rubber bushing conditions of the shock absorbers and torsion bar. | |
Installation: Install new self-locking nuts. | |||
Rear shock absorbers' nuts | |||
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
8 | Unscrew the hydraulic pipe (16) from the connection (18) | | |
Installation: Remove air from the brake system. | |||
9 | Loosen the coupling flange or yoke on the rear axle side and secure the propeller shaft (8) to the chassis | Pre-mark the original position between the flanges or coupling forks of the propeller shaft and the axle to maintain balance. | |
10 | Insert an appropriate lifting device under the rear axle and lift it slightly | Do not lift the vehicle from the differential housing. | |
11 | Loosen the nuts (5) and remove the spring U-bolts (4) and the upper guide plates (3) from the spring U-bolts (4) | Installation: Clean the spring U-bolts threads and lubricate. | |
Spring "U" bolt | |||
12 | Lower the axle and remove it | ||
13 | Install in reverse order |
Rear axle shock absorbers |
Number | Designation | Model 688 | ||
BA32.25-B-1001-03A | Rear shock absorbers' nuts | M12x1.5 | Nm | - |
M14x15- steel 8 | Nm | 108 | ||
M14x1,5 (ISO) | Nm | - | ||
M16x1,5 - steel 8 | Nm | - | ||
M16x1,5 - with flange | Nm | - | ||
M16x1.5 | Nm | - | ||
M16x2 (ISO) | Nm | - | ||
M20x1,5 - steel 8 | Nm | - | ||
M20x1,5 - steel 10 | Nm | - | ||
M24x2- steel 10.9 | Nm | - |
Referenced documents
- ap3500b3501c Rear axle - oil change
- ar4010b1100f Remove/install wheels
- as4250z000101a Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid