ar3330b045804ta

Preparing drive pinion for installation

Type ar · topic 33.30 · version 0101 · 2016-02-12

Applies to:

Where it sits

Function group 2 Chassis › 33 Front axle › 33.30 Final drive, differential, drive shaft — Series 958 (models 0**)

EinPAS 17 Drivetrain/axle › 17.50 Front axle › 17.50.65 Front axle differential/axle through drive — Series 958 (models 0**)

Also applies to engines/gearboxes: 733 050

AR33.30-B-0458-04TA

Preparing drive pinion for installation

Clamp for fastening the assembled drive conical gear

WF58.50-B-3530-05B

Preparing drive pinion for installation

745 589 00 33 00

Extraction device

Preparing drive pinion for installation

D35.30-0121-01

1 Place the clamp (16) around the outer rings of the tapered roller bearing and fix the pinion to the lathe.

2 Install the extraction device (17) with two screws (18) on the coupling flange (9) so that screws press the screw collar (10) with approx. 30 Nm and the extraction device is plan in the coupling flange (9).

Thus, the outer rings of tapered roller bearings are axially tensioned and halves of compensation rings can't slip inside oil slot while extracting the pinion.

Preparing drive pinion for installation

D35.30-0120-01

1 Pinion

2 Ring

3 Inner anti-friction bearing

4 Outer anti-friction bearing

5 Locking plate

6 Spacer washer

7 Radial seal ring

8 Nut with collar

9 Coupling flange

10 Screw collar

11 Oil slot of the screw collar

12 Spacer ring

13 Halves of compensation rings

14 Spacer washer

15 Cylindrical anti-friction bearing