P33.20-0257-01
P33.20-0009-01
P33.20-0010-01
| Removing, installing | ||
| The shock absorber must be installed, or the spring removed, in order to remove and install the upper wishbone. | ||
Installation | Replace self-locking nuts and bolts | ||
1 | Detach steering knuckle (5) from upper wishbone (6) and fasten on spring tower | Do not stretch the brake hose and | |
| |||
Open the clamp connection using the spreader (019) if it is stiff | | ||
2 | Unscrew upper wishbone with bearing shell (6a) from frame | | |
Observe technical modification | |||
| Upper wishbone mount changed to torsion mount | ||
Check and adjust installed position of upper wishbone relative to bearing shell | |||
| |||
3 | Check follower joint | ||
4 | Install in the reverse order |
Test values for wheel location, wheel hub
Number | Designation | Model 140 | ||
BE33.20-P-1001-01A | Test dimension "A" for adjusting the upper wishbone in the bearing shell | mm | 63 | |
See figure | ||||
Front axle carrier
Number | Designation | Model 140 | |
BA33.10-P-1001-01A | Self-locking bolt, bearing shell of upper wishbone to front end | Nm | 50 |
Wheel location, hub
Number | Designation | Model 140 | ||
BA33.20-P-1001-01A | Self-locking nut, clamp connection of upper wishbone to steering knuckle | Nm | 125 | |
BA33.20-P-1008-01A | Self-locking nut, upper wishbone in bearing shell | Nm | 120 | |
140 589 02 31 00
Spreader
Referenced documents
- ar3320p0425a Checking supporting joint and follower joint of steering knuckle mount (removed)
- ar3320p050002a Check/adjust installation position of upper transverse control arm relative to bearing shell
- ar3325p050001a Detaching and attaching steering knuckle on upper wishbone
- bt3320p940101a Upper wishbone mount changed over from plain rubber mount to torsion mount