ar3235p3328fb

Remove/install front stabilizer bar link rod

Type ar · topic 32.35 · version 0100 · 2005-03-04

Applies to: MODEL 454.0 with ENGINE 122.950

Where it sits

Function group 2 Chassis › 32 Suspension › 32.35 Stabilizer — Series 454 (models 0**)

EinPAS 17 Drivetrain/axle › 17.50 Front axle › 17.50.41 Transverse control arm/control arm/stabilizer bar — Series 454 (models 0**)

Also applies to engines/gearboxes: 122 950

AR32.35-P-3328FB

Remove/install front stabilizer bar link rod

6.12.04

MODEL 454.0 with ENGINE 122.950

Remove/install front stabilizer bar link rod

P32.35-2029-06

1 Nut

2 Link rod

3 Rubber bushing

4 Nut

a Dimension

Remove/Install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates below the hoist support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Raise vehicle.

2

Unscrew nut (4) on link rod (2)

Replace self-locking nut (4).

*BA32.20-P-1002-01K

3

Unscrew nut (1) on link rod (2) and remove with rubber bushing (3)

Replace self-locking nut (1).

Installation: Check the rubber bushing (3) of the link rod (2), replace if necessary.

Set dimension (a) by turning the nut (1).

Dimension (a) corresponds to 5 mm.

4

Remove link rod (2) with rubber bushing (arrow)

Installation: Check the rubber bushing (arrow) of the link rod (2), replace if necessary.

5

Install in the reverse order

Front axle torsion strut

Number

Designation

Model
454.0

BA32.20-P-1002-01K

Nut, link rod to torsion bar

Nm

28

Referenced documents