Remove/install rear air suspension level sensor

AR32.22-S-0018E

Remove/install rear air suspension level sensor

04.09.2020

Model

447, 448

with code CA4 (AIRMATIC)

Shown on left side of vehicle

1

Level sensor

3

Electrical connector

5

Trim

2

Screw

4

Link rod

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Notes on air suspension

AH32.22-N-1000-01E

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Raise vehicle.

AR00.60-S-1000E

2

Remove trim (5).

AR35.25-S-2200-01E

3

Disconnect electrical connector (3).

4

Remove link rod (4) from lever of level sensor (1).

 To do so, unclip link rod (4).

 Installation: Link rod (4) must engage audibly on ball head on lever of level sensor (1).

5

Remove level sensor (1).

 To do this, remove screws (2).

 Screw, rear axle level sensor to bracket

*BA32.22-N-1001-03EA

6

Install in the reverse order.

 Component parts of air suspension

Number

Designation

Model 447, 448
with code CA4 (AIRMATIC)

BA32.22-N-1001-03EA

Screw, rear axle level sensor to bracket

Nm

4