ar3220l0230va

Removing and installing rear spring

Type ar · topic 32.20 · version 0100 · 2003-03-13

Applies to: MODEL 414.700

Where it sits

Function group 2 Chassis › 32 Suspension › 32.20 Steel springs, torsion bars, Niveaumat — Series 414 (models 700)

EinPAS 20 Chassis › 20.16 Suspension › 20.16.30 Spring/air suspension bellows/shock absorber/suspension strut — Series 414 (models 700)

AR32.20-L-0230VA

Removing and installing rear spring

5.9.00

MODEL 414.700

Removing and installing rear spring

L32.20-0013-05

1 Rear spring

054 Spring compressor

054a Clamping plates

Removing, installing

1

Jack up vehicle

2

Install clamping plates (054a) in spring compressor (054)

*210589003100

*210589106300

3

Attach spring compressor (054) to rear spring (1)

At least three coils must be clamped in order to compress the rear spring (1) sufficiently.

Danger!

Risk of injury with trapped or crushed fingers when working on springs or spring-loaded components

Use only approved tensioning devices; additionally shield off hazardous area if necessary.
Inspect special tools for damage and proper operation (visual inspection).
Wear protective gloves.

AS00.00-Z-0001-01A

4

Compress and remove rear spring (1)

Installation: Ensure that the rear spring (1) is properly seated.

5

Install in the reverse order

6

Adjust headlamps

Only if the springs are replaced.

AP82.10-P-8260B

Removing and installing rear spring
Removing and installing rear spring

210 589 10 63 00

Clamping plates

Spring compressor

210 589 00 31 00

Referenced documents