ar3020d2000ad

Remove/Install electronic accelerator

Type ar · topic 30.20 · version 0100 · 2012-05-29

Applies to: ENGINES 900, 904 in MODEL 668, 670

Where it sits

Function group 1 Engine › 30 Throttle control, speed control systems › 30.20 Electronic accelerator (EA)/cruise control (CC)/idle speed control (ISC) — Series 668 · Series 670 · Series 900 · Series 904

EinPAS 15 Engine › 15.45 Engine management › 15.45.35 Throttle control — Series 668 · Series 670 · Series 900 · Series 904

AR30.20-D-2000AD

Remove/Install electronic accelerator

7.5.12

ENGINES 900, 904 in MODEL 668, 670

Remove/Install electronic accelerator

D30.20-0007-02

1 Screw/bolts

R40 Foot throttle actuator with idle switch

 	Remove/install
1	Disconnect electrical connector on accelerator pedal with an idle switch (R40)
2	Remove screws/bolts (1)
3	Remove accelerator pedal with an idle switch (R40)
4	Install in the reverse order
5	Reteach-in accelerator pedal with an idle switch (R40) using Star Diagnosis	Only if the accelerator pedal with an idle switch (R40) was replaced for vehicles up to 31.12.09.	AD00.00-L-2000-04A
 Danger!	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
6	Perform an engine test run and function test

Referenced documents

ad0000l200004a Connect STAR DIAGNOSIS and read out fault memory
as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.