ar2719s0200b

Removing and installing electrohydraulic control module (transmission installed)

Type ar · topic 27.19 · version 0103 · 1999-08-11

Applies to: ENGINE 104.900 in MODEL 638.2

Where it sits

Function group 2 Chassis › 27 Automatic transmission › 27.19 Transmission - electrical system — Series 638 (models 2**)

EinPAS 17 Drivetrain/axle › 17.20 Transmission › 17.20.11 Control unit/relay — Series 638 (models 2**)

EinPAS 17 Drivetrain/axle › 17.20 Transmission › 17.20.35 Controller unit/timing case/oil distributor plate — Series 638 (models 2**)

Also applies to engines/gearboxes: 104 900

AR27.19-S-0200B

Removing and installing electrohydraulic control module (transmission installed)

2.6.97

ENGINE 104.900 in MODEL 638.2

Removing and installing electrohydraulic control module (transmission installed)

S27.19-2524-09

1 Oil pan

2 Oil filter

3 Connector

6 Slide

7 Actuating rod

4 Screw

5 Electrohydraulic control unit

Removing, installing

1

Remove oil pan (1)

AR27.10-S-7030C

Risk of damage due to the effect of dirt in transmission

Use fluff-free rags

2

Remove oil filter (2)

Pull off oil filter (2) downwards.

3

Disconnect connectors (3) from wiring harness

Risk of kinking and fracture

4

Unscrew screws (4) from electrohydraulic control unit (5)

Fit screws (4) evenly and tighten in a criss-cross pattern.

*BA27.19-N-1006-02A

*000589011000

5

Remove electrohydraulic control unit (5)

Only pull out slide (6) until the actuating rod (7) can be unhooked.

The slide (6) remains in the electrohydraulic control unit (5).

Secure slide (6) to prevent it from falling down.

6

Install in reverse order

Electrical system, transmission

Number

Designation

Model 638 with engines 111, 601.970, 611.980

Model 638 with engine 104.900

BA27.19-N-1006-02A

Screw, slide box to transmission

Nm

–

5

Removing and installing electrohydraulic control module (transmission installed)

Set of Torx bits

000 589 01 10 00

Referenced documents