P27.19-2788-07
1 | Electrical connector | 3 | Sealing ring | ||||
2 | Screw | B108 | Rpm sensor 1, transmission input shaft with direction detection |
P27.19-2789-07
1 | Electrical connector | 3 | Sealing ring | ||||
2 | Screw | B109 | Rpm sensor 2, transmission input shaft |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Switch off ignition and remove transmitter key | ||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
2 | Raise vehicle | When removing transmission input shaft rpm sensor 1 with direction marker (B108). | |
3 | Remove covering over engine | When removing transmission input shaft rpm sensor 2 (B109). | |
4 | Release and disconnect electrical connection (1) | ||
5 | Unscrew bolt (2) | ||
6 | Pull out transmission input shaft rpm sensor 1 with direction marker (B108) or transmission input shaft rpm sensor 2 (B109) | Installation: Check sealing ring (3). | |
If there are problems | |||
| |||
Replace sealing ring (3). | |||
7 | Install in the reverse order |
Referenced documents
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.