AR27.10-P-0200A | Removal and installation of control pressure cable with vacuum actuator | 7.9.94 |
TRANSMISSION 722.5
P27.10-0250-01
P27.10-0249-01
7 Vacuum actuator, program selector switch
8 Vacuum actuator, shift point retard
9 Hexagon bolt
10 Locking tab
98 Control pressure cable
A Vehicles with program selector switch
B Vehicles with shift point retard, control cable actuator and program selector switch
| Removal, installation | ||
1 | Remove air cleaner | ||
2 | Press off ball socket, compress plastic clips with pliers and remove control pressure cable from throttle linkage on engine | ||
3 | Disconnect all vacuum lines on the vacuum actuators of the control pressure cable | ||
4 | Loosen control pressure lock on transmission with a screwdriver (arrow) | Version A | |
5 | Loosen hexagon bolt (9) and twist lock plate (10) upwards using a screwdriver | Version B | |
6 | Turn control pressure sideways and remove from the transmission | Installation: When inserting the control pressure cable in the transmission housing, insert the connecting and limiting rod. | |
| Control pressure cable with vacuum actuators standardized | Transmissions 722.3/4/5 | |
7 | Install in reverse sequence | ||
8 | Basic setting of control pressure cable (after replacement) | ||
9 | Adjust control pressure cable on throttle linkage |
Referenced documents
- ar0910p1050d Removing and installing air cleaner
- ar2710p0120a Adjusting control pressure cable on throttle linkage
- ar2710p0220a Basic setting of control pressure cable (after replacement)
- bt2710p000301a Control pressure cable with vacuum actuators standardized