AR26.60-B-0010E | Remove/install shift forks and shift rails | 12.02.16 |
Manual transmission 718.180, 718.182, 718.183
B26.30-0036-05
1 Pivoting pin
2 Shoe
3 Overdrive fork
4 Overdrive selector
5 Selecting key
6 Selection rod
7 locking key
8 3rd/4th speed selection fork
9 Pin
10 Selection block locking bolt
11 Selection block
12 1st/2nd selection fork
13 Reverse/low fork
| Disassembling | ||
1 | Put the selection forks set in a bench with the selection block (11) to the left | Mark the position of the axle and fasten with a cotter to facilitate the assemblage. | |
2 | Hold the set by the selection block (11) and remove the locking cotter from the rear part | ||
3 | Remove the selection forks (8), (12), (13). Remove the bolts (10) from the selection block and slide them out of the rod (6) | ||
| Assembling | ||
4 | Put the selection cotter (5) in the opening of the selection rod with the three flanges forward | Pay attention to the marks you made during the disassembly. | |
5 | Put the selection block (11) on the rod (6) and tighten the bolt (10) | If the bolt is not replaced, put a sealing thread before the installation. | |
| |||
6 | Put the forks (8), (12), (13) in their respective places in the selection rod (6) | ||
7 | Support the selection rod (6) and slide the locking cotter (7) by the back |
Shift mechanism
Número | Denominação | Gearboxes 718.180/182/183 | |||
BA26.60-B-1005-01G | Shifter lever fastening | M8 | Nm | 20...27 | |
M10 | Nm | 35...39 | |||
Produtos para reparos
Número | Denominação | Número de pedido |
BR00.45-B-1018-01A | Sealant | Loctite 515 |